COMPLEX RADIO CONTROL SYSTEM
Wireless connection is only possible when a receiver is in
“Normal“
mode (
MeasureOrSetting->Main Setting ->Rx mode: Normal
).
The JETIBOX can be disconnected only after you disconnect the
receiver voltage supply. You may monitor the on-board state of
your receiver during your model‘s operation. Pay particular
attention, of course, to your setup work. If it is possible, we do not
recommend changing setup parameters during model
operation. Set-up work should only be done if there is no danger
of damaging the model or injuring people. For safety reasons
prevent motor activation or remove the propeller!
5.2. Receiver set-up via the DC/DS transmitter
You can find this option at JETI DC/DS transmitters in the
menu/model/device explorer. The requirement for correct function
is the actual SW in the receiver and transmitter. Receiver and
transmitter updates are available in JETI Studio.
EN
15