computer radio control system
6.4 Out pin set
Setup of the physical receiver outputs.
Set Output pin
- selection of output, which goes for the following
setup. The menu item shows, as a decimal number, the throw of the
selected output. Receiver output 1 is labeled as Y1.
Pin Config
- receiver pin config can be:
Servo
ź
standard impulse output for servos
(-100% = 1ms, 0%= 1,5ms / +100% = 2ms )
Digital
ź
the output pin is in a stable LOW condition (log. 0) if the
position of this channel is negative, otherwise this pin is in
HIGH condition (log.1)
ź
ensure that pin is used only as logical output, don't draw the
current above 1mA
Input
ź
here the pin is configured as an input and its condition
(disconnected/connected to the ground) is sent to the
transmitter as other telemetry data from the sensors
ź
it is allowed to keep the pin disconnected or connected to the
common ground of the receiver
ź
it is not allowed to connect to a different voltage. The pin
works exclusively in PullUp mode so all you need to test the
function is to connect the signal pin to the ground.
PPM pos
.
- standard form of PPM signal generation with
positive logic at PPM outputs. The bus idle state is log. 0.
EN
15
®
User Manual
User Manual
EN
FW 1.00
Receivers REX
FW 1.00
COMPLEX RADIO CONTROL SYSTEM