Jetboil Genesis, Instructions Manual

Page: 9 / 44

8
3. Pull Rubber Latches (2.1) free from Catches (2.2)
4. Rotate the Top Stove (2.3) to open stove. Latches may be rotated
under the Bottom Stove (2.4) if desired.
5. Perform LEAK CHECK PROCEDURE (see pg. 4) before proceeding.
6. Ensure that both control valves (3.1) are closed firmly
(rotate clockwise).
7. Check that Gasket (4.4) at Fuel Input connection (4.2) is in place and
in good condition before connecting to the Regulator.
Do not use the appliance if it has damaged or worn seals;
this may result in gas leakage.
8. To check that the gas canister is not empty, liquid fuel may be heard
and/or felt inside when the canister is shaken.
9. Connect Fuel Regulator (4.1) to the Fuel Input port (4.2)
located in the rear of the left side of the stove by threading
Coupling clockwise.
10. Connect Propane Cylinder (4.3) (sold separately) into Fuel regulator (4.1)
by threading clockwise in the orientation shown in Fig. 4.
Do not install or use Fuel Cylinder in an inverted position.
11. To attach Windscreen (1.4), press Windscreen arms into slots in four
Bumpers (5.1) located at the back and sides of the stove until the
dimples (5.2) snap into place inside each Bumper.
Prior to initial use, remove plastic backing on both sides
of the Windscreen.
Ensure a 1" minimum gap between Windscreen and any
cookware used when Windscreen is attached.
WARNING
WARNING
NOTICE
NOTICE