Jet WiFi Messenger Alarm Quick Start Download Page 4

   Troubleshooting Guide

Network status light fl ashes:

One Flash Every Five Seconds:

 No WiFi can be found. Verify wireless router is powered

and functioning. Verify alarm is within range of wireless router.

Two Flashes Every Five Seconds:

 An IP address cannot be obtained. Cycle the power to

your wireless router. Enable DHCP in your router set up (see router manufacturer’s
user’s 

manual).

Three Flashes Every Five Seconds:

 Email is unable to be sent. Verify the internet

connection is functioning. Verify the email address is valid.

Alarm webpage is not found

:

Alarm is not connected to a wireless network. Connect to the wireless network according to
the setup instructions.

Your internet connected device (laptop, desktop, tablet, smartphone, etc.) is not connected
to the same wireless network as the alarm. Connect your device to the same wireless
network as the alarm.

The correct Unit ID# was not entered into the browser: 

www.mywifi alarm.com

. Follow the

registration link. Re-enter the correct Unit ID# for your alarm.

Notification emails or text messages are not received:

Email address or cellular information was not set up correctly. Verify email addresses are
valid and/or cell numbers are entered correctly.

Internet access is not functioning. Repair the internet connection.

Notifi cation

 

email has been blocked. Unblock or allow emails from

[email protected] 

 in your email account.

The 

JET 

WiFi Messenger Alarm terms and conditions have not been accepted 

and/or a

v

eri

      fication email has not been sent

. Follow steps in the “Verifi cation” section.

Congratulations!

Your 

JET

 WiFi Messenger Alarm 

is now confi gured and ready to be used.

(Remember to test your alarm on a regular basis to ensure proper operation)

 

E4

01/25/2019

QA-SAL-357

JET

® 

is a registered trademark of Jet, Inc.

Summary of Contents for WiFi Messenger Alarm

Page 1: ...ireless router for WiFi connections This quick start manual covers setup using a WPS connection to your wireless network STEP 1 WiFi Network Setup WPS The blue network status light will illuminate steadily when the JET WiFi Messenger Alarm is successfully connected to the wireless network POWER WPS INTERNET E1 1 Press the WPS button on your wireless router often the back side of router 2 Press the...

Page 2: ...Enter your email address and press the Request Verification Code button Note All future alarm notifications will be sent to this verification email address in addition to the email addresses entered on the JET WiFi Messenger Alarm s setup page 7 An email will be sent to the verification email address entered with a link to the Notification Setup page Click this link to access the Notification Setu...

Page 3: ...text Note It may take several minutes for the message to appear in your email inbox or message folder depending upon email server traffic or other circumstances If you have not received a notification within 5 minutes verify the email address and or cellular phone information is entered correctly and that any email filters are set to allow messages from mywifialarm mywifialarm com While using a Wi...

Page 4: ...the alarm Connect your device to the same wireless network as the alarm The correct Unit ID was not entered into the browser www mywifialarm com Follow the registration link Re enter the correct Unit ID for your alarm Notification emails or text messages are not received Email address or cellular information was not set up correctly Verify email addresses are valid and or cell numbers are entered ...

Reviews: