Jet SuperSaw JWSS-10CS, Operating Instructions And Parts Manual

Page: 16 / 44

16
table, until it is level with the saw table
(Figure 17). As one part of the edge becomes
level with the table, tighten the clamp on that
side. Then move to the other side and repeat,
until the full length of the edge is level with the
saw table. Lay a straight edge across both
extension table and saw table to ensure proper
leveling.
When the extension table is properly aligned, holes
need to be drilled into the wood table using the
holes in the rails as your guide (Figure 18).
You
may wish to drill 3/32" pilot holes first .
3. Drill 1/4" holes into the front edge of the table
using the holes in the front rail as a guide. Drill
1/4" holes into the back edge of the table using
the holes in the back rail as a guide.
4. Install three each 1/4 x 1-1/2 hex cap screws,
six 1/4 flat washers, 4/1" lock washers and 1/4
hex nuts into the holes in the front edge of
extension table as shown in Figure 19. Finger
tighten only.
5. Repeat Step 4 for the back rail.
6. Re-check the table for alignment, make further
adjustments if necessary, then tighten all
screws and nuts.
7. Mount the two legs to the inside corners of the
extension table as shown in Figure 20. Secure
with the eight screws provided.
Note : If you are using a mobile base under your
saw, you may need to shift the placement of the
legs so they rest properly upon the shelves of the
base.
8. Adjust the footpads on the legs
counterclockwise until they reach the floor,
then tighten the nut.
Guide Tube
The guide tube is placed on top of the front rail and
is mounted with the black unpainted surface
positioned toward the operator.
If your left table wing is the "fixed" type with miter
slot (A. Fig. 21), orient the guide tube (B) with
respect to the rail (C) as shown in Figure 21.
If your left table wing is the sliding table type
(D, Fig. 22), mount the guide tube (F) so it lines up
with the left edge on the angle iron portion of the
rail (E).
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22