Jet SuperSaw JWSS-10CS, Operating Instructions And Parts Manual

Page: 12 / 44

12
The fence on the miter gauge must not contact
the saw blade! Failure to comply may cause
serious injury!
3. You can adjust the play in the miter gauge by
tightening the setscrews (J, Fig. 7).
Note: Always make test cuts to verify the angle.
Mounting Sliding Table
Hardware: Sliding Table, (4) M8x25 Hex Cap
Screws, (4) M8 Hex Nuts, (8) M8 Flat Washers, (4)
M6 Hex Nuts, (4) M6x25 Socket Head Cap
Screws, (2) Flat Shims & (2) 90° Shims
Tools: Straight Edge, (2) 13mm Wrenches, 10mm
Wrench, 5mm Hex Wrench
Referring to Figure 8:
The procedure for installing the leveling brackets is
the same for front rail and back rail. The illustration
(Figure 8) shows the front rail.
1. Place two washers (B) on two M8x25 hex cap
screws (A). Insert through the mounting slots
of the front rail (C) and secure to the threaded
holes of the leveling bracket (D). Thread
screws only until they begin to protrude
through the leveling bracket at this time.
2. Thread two M6 hex nuts (F) all the way onto
the four M6x25 socket head cap screws (G)
and screw into the leveling bracket (D).
3. Install the remaining leveling bracket onto the
back rail repeating the procedure outlined in
Steps 1 and 2 .
4. The arbor pulley guard (H, Fig. 9) should be
attached to the saw cabinet.
5. You need to leave a gap between rails
(C, Fig 8) and the brackets (D, Fig. 8) so that
you can set the sliding table in position.
6. Mount table lock knob (J, Fig. 9) to the sliding
table (K, Fig. 9) with two M6x12 socket head
screws. Rotate knob 90° to engage/disengage
lock.
Make sure that the lock knob is
in the locked position and that the table is
locked (does not slide on its support plate).
Failure to do so could result in injury when
attempting installation!
7. Place the sliding table (K, Fig. 9) onto the
leveling brackets (L, Fig. 9).
Figure 8
Figure 9