15
4. Keep the same settings and begin a second cut
on the same or similar workpiece.
5. When blade has completed about 1/3 of cut,
increase feed rate. Watch chip formation until
cutting is at its most efficient rate (
sect. 9.5
) and
allow saw to complete the cut. The blade is now
considered ready for regular service.
10.0
User-maintenance
Always disconnect power to
machine before performing maintenance.
Failure to comply may result in serious personal
injury.
10.1
General cleaning
Keep wheels clear of chips and debris.
Keep slide areas (such as vise ways and T-slot,
slide for bow swivel, and behind the scale where the
guide posts slide) clean and oiled.
Keep a light coat of SAE 10W oil on machined parts
to inhibit rust.
Keep proximity switches and sensors clear of dirt or
dust.
10.2
Lubrication
All ball bearings are permanently lubricated and
sealed; they require no further attention.
Coolant – Maintain proper coolant level. Clean chip
sludge from coolant tank as needed. Replace
coolant on a frequency appropriate to type of
coolant being used. Oil-based coolants can sour.
Refer to coolant supplier’s instructions for
frequency.
Hydraulic cylinder pivot – apply a light oil every 6
months.
Blade tension screw – grease every 6 months.
Wire brush bearing – apply a light oil monthly.
10.2.1
Hydraulic system
The hydraulic oil tank has been prefilled by the
manufacturer. Check oil level in sight glass (Figure
7-7). If oil needs to be added, pour through fill plug
hole.
10.2.2
Gearbox
The gearbox has been pre-filled by the
manufacturer. After first 50 hours of use the gearbox
should be drained and refilled. After that change oil
every six months.
1. Remove drain plug (A, Figure 10-1) and allow
lubricant to drain completely. Reinstall drain
plug.
2. Remove oil fill plug (B) and fill gearbox with 1
liter (1 qt.) of Mobil
TM
SHC 634 gearbox oil, or
equivalent. Replace fill plug.
Figure 10-1
10.3
Belt replacement
To remove belt, loosen knob and remove tension on
belts (see Figure 7-5). Slip old belts off pulleys and
install new belt. Readjust tension and tighten knob.
NOTE: It is recommended that both belts be
replaced at same time.
New belts may stretch slightly as they get broken in,
so belt tension should be re-checked after a period
of use.
10.4
Additional servicing
Any additional servicing should be performed by
authorized service personnel
11.0
Optional accessory
An optional Roller Stand (part no. 413413) is
available for the MBS-1323EVS band saw. Contact
your dealer or visit our website for more information.
