11
8. Align holes on bed with those in the stand
top and fasten with eight hex socket cap
screws (5/16"x1"), eight lock washers
(5/16"), and eight nuts (5/16") supplied.
Note: Two larger hex socket cap screws and
washers will be used later to attach the bed
extension to the bed.
9. Tighten eight hex socket cap screws with a
hex wrench.
10. Tighten all stand hardware making sure it is
stable on the shop floor.
11. Attach bed extension to bed using two hex
socket cap screws (3/8"x1") and two lock
washers (3/8") supplied.
Referring to Figure 2:
12. Insert index plunger (A, Figure 2) into the
base of the headstock (B, Figure 2) and
tighten.
13. Mount the handwheel (C, Figure 2) to the
headstock. Note: The handwheel must be
removed whenever the drift rod is to be
used.
Referring to Figure 3:
14. Attach the headstock lock handle (A, Figure
3) to the head stock lock shaft (B) with one
spring (C) and one hex socket cap screw
(D).
15. Attach the tailstock handle to the tailstock
handwheel and tighten.
16. Connect the motor cord plug to the switch
plug.
Controls
Speed Selector
(A, Figure 4) - selects one of
six available speeds. Select desired speed by
pulling handle out from headstock and turning to
left or right. Release handle and it will engage
detent for that speed.
Caution: Never change
speeds without motor running. Damage to
the variable speed pulleys may result.
Headstock Lock
(B, Figure 4) - locks headstock
in a fixed position. Tighten clockwise to lock.
Loosen counterclockwise to unlock.
Caution:
always operate lathe with the headstock in the
locked position.
Detent Release
(C, Figure 4) - pull out and hold
to swivel headstock. Release to engage detents
at 90 or 180 degrees.
Figure 2
Figure 3
Figure 4
Summary of Contents for JWL-1236
Page 16: ...16 JWL 1236 Parts Breakdown...
Page 19: ...19 Electrical Connections...