Jet JDP- 8BM, Operating Instructions Manual

Page: 6 / 23

Dimensions 500x320x830mm
Weight
39 kg
Mains 230V ~1/N/PE 50Hz
Output power 0.18 kW (1/4HP) S1
Reference current 2 A
Extension cord (H05VV-F): 3x0.75mm²
JDP-13FM
Spindle to column 168mm
Spindle travel 80mm
Spindle taper MT2/B16
Chuck size 16mm
Column diameter 73mm
Table size Ø300mm
Number of speeds 12
Range of speeds 250 - 2500 rpm
Dimensions 630x400x1590mm
Weight
55 kg
Mains 230V ~1/N/PE 50Hz
Output power 0.375 kW (1/2 HP) S1
Reference current 3 A
Extension cord (H05VV-F): 3x0.75mm²
JDP-20FT:
Spindle to column 257mm
Spindle travel 120mm
Spindle taper MT-4/B16
Chuck size 16mm
Column diameter 92mm
Table size 475 x 425 mm
Overall height 1695 mm
Number of speeds 12
Range of speeds 70 - 1650 rpm
Dimensions 855x575x1695mm
Weight
116 kg
Mains 400V ~3L/N/PE 50Hz
Output power 0.50 kW (3/4 HP) S1
Reference current 3 A
Extension cord (H05VV-F): 5x0.75mm²
4.2 Noise emission
Acoustic pressure level
(according to EN ISO 11202):
Idling
LpA 69,6 dB(A)
In operation LpA 79,0 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Machine base
Column and bracket assembly
Head assembly
Table
Table bracket lock handle
Table bracket rising handle
3 downfeed handles
16mm chuck
Arbor
Chuck guard
Drift key
Operating tools
Assembly kit
Operating manual
Spare parts list.
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in
closed rooms and must be placed
stable on a firm and levelled table
surface. The machine can be bolted
down if required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with a
mild solvent.
Attach the column assembly (A, Fig 1)
to the base (B) with four hex cap bolts
(C).
Tighten firmly.
Fig 1
Thread the table bracket lock handle
(A, Fig 2) into the table bracket (B).
Fig 2
Slide the table bracket rising handle
(B, Fig 3) onto the table bracket shaft.
Fig 3
Turn the handle until the set screw is
opposite the flat section on the shaft
and tighten the set screw (A).
Insert the table into the table bracket.
Tighten the table lock handle.
With the aid of a second person,
carefully lift the head onto the column
top.
Caution:
The head assembly is heavy! Use
care when lifting onto the column!
Rotate the head assembly until the
sides of the belt cover are parallel with
the sides of the base.
Tighten two set screws (A, Fig 4).