9
5.5
Assembling eye shield bracket to
spark guard
Refer to Figure 5-2.
Note:
Spark guard (A) and eye shield bracket (D)
are marked
L
for left side assembly. Assemble the
spark guard and eye shield bracket using Figure 5-
2 as a guide.
Figure 5-2: bracket to spark guard
5.6
Installing spark guard/bracket
Refer to Figure 5-3.
1. Install spark guard and mounting bracket
assembly to the left wheel housing with two
3/8 x 1/2” hex cap screws
(G) and two 3/8" flat
washers (J).
2. The spark guard (A
1
) should be adjusted to
within 1/16"
of the grinding wheel surface or
other accessory being used. As the wheel
wears down, the spark guard must be re-
adjusted to maintain this 1/16" distance.
5.7
Eye shield
Refer to Figure 5-3.
1. Insert two 3/16” x 1/2” truss head screws (H)
through bracket, eye shield
(K), and plate (E)
which contains threaded mounting holes.
2. Tighten screws (H).
5.8
Tool rest
Refer to Figure 5-3.
1. Install tool rest (M) by inserting two 3/8" x 3/4"
hex cap screws (F) through two 3/8" flat
washers (J), through the tool rest (M), into the
wheel housing.
2. The tool rest should be adjusted to within 1/16"
of the grinding wheel or other accessories
being used. As the wheel wears down, the tool
rest must be readjusted to maintain a
maximum 1/16" clearance.
5.9
Dust port
It is recommended that a metalworking dust
collection system be connected to the grinder’s
dust port, using a 2-in. diameter hose with hose
clamp (not provided).
Figure 5-3: guard and tool rest
5.10
Multitool position
The Multitool attachment is pre-installed in
horizontal position. It can be removed and
positioned in vertical orientation as follows.
1. Remove nut (R, Figure 5-4) and slide drive
pulley (S) off shaft.
2. Remove 3 screws and washers (T) and rotate
adaptor plate (U) to vertical position.
3. Reinstall screws and washers, drive pulley and
nut.
Figure 5-4: Multitool orientation
