Jet HVBS-712V, Operating Instructions And Parts Manual

Page: 9 / 32

9
3. Remove shipping bracket (Figure 6-4). Then
reinstall bottom hex nut beneath plate. Retain
shipping bracket in case machine must be
transported in future.
Figure 6-4: shipping bracket removal
4. Install handle with flat washers and nut (C,
Figure 6-5), using 19mm wrench. To install,
raise bow to vertical position and open guard.
CAUTION: Spring-tensioned stop bracket (see
Figure 7-1) must be rotated out of the way
before raising bow.
Figure 6-5: installing handle
5. 712DV only: Install work stop rod (H
1
, Figure
6-6) into hole and tighten knurled nut (H
2
).
Install work stop onto rod threads by rotating
collar (H
3
). Secure position of work stop by
tightening set screw (H
4
) onto rod flat.
Figure 6-6: installing work stop (712DV only)
712V only: Install work stop rod into hole and
tighten knurled nut (H
2
). Slide stop block onto
rod and secure with thumb screw. See Figure
6-7.
Figure 6-7: installing work stop (712V only)
6. Slide pulley cover (A, Figure 6-8) over spindles
and secure with screws and washers
(HP2/HP3), using 10mm wrench.
7. Install lock screw (HP1) to secure pulley cover.
Figure 6-8: installing pulley cover
8. The table plate (B, Figure 6-9) may be used as
cutting table in vertical mode (models 712V and
712DV), or may be used as infeed table in
horizontal mode
(712DV only) . To use as
infeed table for model 712DV, place supports
(F) on channel of saw bed as shown, and install
plate with flat head screws (HP5).
To use plate as cutting table in vertical mode,
refer to sect. 7.2.
Figure 6-9: installing infeed table (712DV only)
9. Place filter assembly (G, Figure 6-10) over drain
hole.