6
Ampere
Rating
Volts
Total length of
cord in feet
More
Than
Not
More
Than
240 50 100
200 300
AWG
0
0
0
6
18
16
16 14
0
6 10
18
16
14 12
10 12
16
16
14 12
12 16
14
12
Not
Recommended
Extension Cord Recommendations
Table 1
7.0
Operation
Make sure pipe notcher is
properly lubricated before operating. Failure to
comply may cause damage to machine.
The Pipe Notcher is shipped with oil in the reduction
box. However, the operator should confirm this
before using the machine! See
sect. 8.0
.
1. Turn
on
machine.
2. Clean pipe end of any dirt, chips, burrs, etc.
3. Insert end of pipe into correct hole, determined
by nominal size of schedule 40 pipe (see Figure
7-1).
NOTE: Insert
only one pipe at a time
into the machine.
4. Continue to lightly press pipe into hole until it
slides farther in and is notched. Pull pipe out.
The scrap will fall to bottom of machine.
5. Remove pipe. It is now ready for saddling and
welding.
Figure 7-1:
Sizes represent nominal dimensions
of SCH 40 pipe
8.0
User-maintenance
Disconnect machine from
power supply before performing any
maintenance. Failure to comply may result in
serious injury.
1. It is recommended that the oil be replaced every
2,500 operating hours. Remove set screw to
drain (Figure 8-1).
Capacity - 2.0L. (approximate)
Recommended oil - see Table 2.
2. Remove cover and clean out any lingering chips
or debris around blade area, as needed.
3. Periodically check tightness of all screws.
Figure 8-1: oil drain
Ambient
temp.
SHELL
OIL
MOBIL
OIL ISO
VG
5
℃
~20
℃
OMALA 150
MOBIL Gear 629 EP 150
20
℃
~40
℃
OMALA 320
MOBIL Gear 632 EP 320
40
℃
~80
℃
OMALA 460
MOBIL Gear 634 EP 460
Table 2
8.1
Additional servicing
Any additional servicing should be performed by an
authorized JET service center.
