11
Electrical Connections
All electrical connections must
be done by a qualified electri-
cian. All adjustments or repairs must be done
with the dust collector disconnected from the
power source, unplugged. Failure to comply may
result in serious injury!
The DC-650 (all models) dust collectors are rated at
115/230V, Prewired 115V
. Use a plug and outlet
rated at least 20 amps. The circuit for the machine
should also be protected by at least a 20 amp circuit
breaker or fuse. Keep in mind that a circuit being
used by other machines, tools, lights, heaters, etc. at
the same time will add to the electrical load.
A dedicated circuit to the dust collector will give you
the best results since dust collectors are generally
used at the same time other tools are running.
Turning the Machine On & Off
This machine is intended for
indoor use only.
All Models
Before hooking up to the power source, make sure
that the switch is in the off position.
Turn the dust collector on by pulling up on the paddle
switch. Push switch down to stop the dust collector.
The switch has a removable safety key (Figure 10) to
prevent unauthorized operation of the machine. Pull
out the key and store in a safe place. Key must be
reinserted to operate dust collector.
Figure 10
Remote Control (Optional)
The DC-RC RF Remote Power Control unit is
available as an optional accessory (contact your JET
dealer or Customer Service by calling the number on
the cover).
Important:
The DC-RC Remote Power Control
(SN
708636C)
can be used for activating Dust Collection
units powered by 115V
only
up to 1-1/2HP. If your
dust collector is currently set up for 230V operation or
you choose to convert it to 230V at a later time, you
must purchase the DC-RC230 Remote Power
Control unit (SN 708636D).
Figure 11A Figure 11B
Dust Collector RF Remote
Power Control
(Optional)
The
DC-RC
Remote Power Control
(Figure 12)
should be used for activating Dust Collection units
powered by 115V only up to 1-1/2HP. The DC-RC
Remote Power Control
unit is rated at
115V, Single
Phase
only. Use an outlet rated at least 20amps. The
circuit for the device being controlled by the DC-RC
should also be protected by at least a 20 amp circuit
breaker or fuse.
Before hooking up to the power source, make sure
that the switch is initially in the off position on both
the dust collector and
remote control unit
(Figure 13).
Figure 12
Turning the DC-RC
On & Off
This machine is intended for
indoor use only.
1. Plug the dust collector into the
main unit
(Figure 12) and plug the main unit into the power
outlet.
To start a machine or device:
2. Turn the machine itself on.
