12
Canister Kit Assembly
If you purchased Model DC-1200CK or DC-1200CK-3
Dust Collector, this section describes the assembly
and installation of the contents of the Canister Kit
(SN 708636F).
Canister Filter
1. Mount the handle onto the canister filter with two
M10 hex nuts, two M10 flat washers, and a M10
lock washer (Figure 10).
2. Mount the canister filter on top of the
collector
housing
(A, Fig. 5) and tighten the knobs on the
canister filter
(Figure 10).
Collector Bag
3. Place the ring over the top of the plastic bag and
fold over the bag approximately three inches,
Figure 11.
4. Insert the
snap ring
(A, Fig. 12) of the collector
bag into the bottom of the housing at an angle.
5. Pull down on the ring to make sure it “seats” in the
housing.
Note:
make sure the snap ring “snaps” into place
in the housing, and also that the plastic bag hangs
down approximately 3” so that there are no air
leaks.
Figure 10
Figure 11
Figure 12
Summary of Contents for DC-1200BK
Page 16: ...16 Parts Breakdown for the DC 1200 Dust Collector ...
Page 23: ...23 ...
