12
Canister Kit Assembly
If you purchased Model DC-1100VX-CK Dust
Collector, this section describes the assembly and
installation of the contents of the Canister Kit
(SN 708639B).
Canister Filter
1. Mount the handle onto the canister filter with two
M10 hex nuts, two M10 flat washers, and a M10
lock washer (Figure 10).
2. Mount the canister filter on top of the
collector
housing
(A, Fig. 5) and tighten the knobs on the
canister filter
(Figure 10).
Collector Bag
3. Place the snap ring over the top of the plastic bag
and fold the bag over the ring approximately three
inches, as shown in Figure 11.
4. Insert
the
snap ring
(A, Figure 12) of the collector
bag into the bottom of the housing at an angle.
5. Pull down on the snap ring to make sure it seats in
the housing.
Note:
Make sure the snap ring “snaps” into place
in the housing, and also that the plastic bag hangs
down approximately 3 inches so that there are no
air leaks.
Figure 10
Figure 11
Figure 12
Summary of Contents for DC-1100VX-CK1
Page 16: ...16 Parts Parts Breakdown DC 1100VX Dust Collectors...
Page 22: ...22 Wiring Diagram DC 1100VX Dust Collectors...
Page 23: ...23...
