10
6. Install the
housing
(A, Fig. 5) to two
support
legs
(B, Fig. 5) using four M8 x 16 hex cap bolts,
eight M8 flat washers, and four M8 hex nuts (C,
Fig. 5).
Be sure hose opening faces fan housing.
Note:
For filter bag models only – Before attaching
third support bracket place the
hanger bracket
(D,
Fig.5) between the support bracket and the
housing. This action is not necessary for canister
filter units.
7. Tighten all nuts and bolts at this time with a 13mm
wrench.
Cone Assembly
Referring to Figure 6:
8. Mount the cone
support bracket
(E) to the housing
with four M6x12 hex cap screws (F), and tighten
from beneath with four M6 hex nuts (G).
9. Install
the
cone
(H) from beneath using the M8x16
hex cap screw (J), M8 flat washer (K), and M8 hex
nut (L), and tighten.
Hose
Referring to Figure 7:
10. Attach the
hose
(B) between the collector
housing
(A) and the
impeller housing
(D) with two
clamps
(C). Tighten the clamps to secure the hose.
This completes the
Base Unit
assembly. If you
purchased the
DC-1100VX-BK or DC-1100VX-5M
Dust Collector
(filter bag versions), continue on the
following page. If you purchased the
DC-1100VX-CK
Dust Collector
(canister filter version), proceed to
Canister Kit Assembly
section on page 12.
Figure 5
Figure 6
Figure 7
Summary of Contents for DC-1100VX-CK1
Page 16: ...16 Parts Parts Breakdown DC 1100VX Dust Collectors...
Page 22: ...22 Wiring Diagram DC 1100VX Dust Collectors...
Page 23: ...23...
