Jet CL-1640ZX, Operating Instructions Manual

Page: 8 / 56

8
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Lathe
is
assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
1 Lathe
1 10” Three-Jaw Chuck (mounted on Lathe)
1 12” Face Plate
1 Laptop Computer Tray
1 Air Hose with Blower Gun
1 Anilam
®
Controls manual
1 Operating Instructions Manual
1 Parts List & Electrical Diagram Manual
1 Warranty Card
1 Tool Box containing (see Figure1):
1 Open End Wrench Set
1 Hex (Allen) Wrench Set
1 Spindle Sleeve
1 Live Center, MT-4
1 Dead Center, MT-5
6 Leveling Bolts
6 Leveling Pads
1 Flat Blade Screwdriver
1 Cross Point Screwdriver
1 Chuck Key
1 Tool Post Wrench
1 Cam Wrench
1 Adjustable Wrench
1 Oil Gun
1 Touch-up Paint Can
1 Gap Bridge Pin Driver
1 Wedge
1 Serial Cable
5 Extra Fuses
2 Sets of keys (electrical box/main switch)
Figure 1
contents of Tool Box
Read and understand the entire contents of this manual before attempting set-
up or operation! Failure to comply may cause serious injury.