Jet CL-1640ZX, Operating Instructions Manual

Page: 7 / 56

7
Specifications
Model Number .................................................................................................................... CL-1640ZX
Stock Number .......................................................................................................................... 320930
Computer Controls:
Anilam 4200T with 12.1” TFT Color Flat Screen
8.0 GB Hard Drive with Flash Memory, 266MHz Dual Processor
floppy disk drive; flash card reader
Spindle Motor ............................................................................................ 10HP, 3Ph, 220V only, 60Hz
Servo Motors ........................................................................................................................ 1.0/1.5KW
Capacities:
Swing over Bed (in.).......................................................................................................................... 16
Swing over Cross Slide (in.) .............................................................................................................. 10
Maximum Swing Through Gap (in.) .............................................................................................. 25-7/8
Length of Gap (in.) ...................................................................................................................... 12-1/4
Distance between Centers (in.) .......................................................................................................... 40
Spindle Bore (in.) .......................................................................................................................... 3-1/8
Spindle Mount .............................................................................................................................. D1-8
Spindle Taper ............................................................................................................................... MT-7
Range of Spindle Speeds (RPM) ........................................................ infinitely variable within 80 to 2000
Rapid Feed, X-axis (in./min.) ........................................................................................................... 315
Rapid Feed, Z-axis (in./min.)............................................................................................................ 394
Minimum Input (X/Z)(in.)............................................................................................................0.00004
Tool Post..................................................................................................................4 station automatic
Maximum Tool Size (in.)................................................................................................................ 1 x 1
Maximum Cross Slide Travel (X) (in.) ................................................................................................... 9
Maximum Carriage Travel (Z) (in.) ..................................................................................................... 35
Tailstock Spindle Travel (in.)................................................................................................................ 5
Tailstock Taper ............................................................................................................................. MT-5
Width of Bed (in.) ........................................................................................................................ 13-1/4
Overall Dimensions (in.)(LxWxH) ........................................................................................ 50 x 92 x 64
Approximate Net Weight (lbs.) ....................................................................................................... 5566
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Walter Meier (Manufacturing) Inc., reserves the right to change specifications at
any time and without prior notice, without incurring obligations.