Cold Metals Lab
V1.0 11/7/2017
Notes
•
Never hold a piece smaller then half the vice width in the jaws
•
If blade is skipping turn down the cutting pressure
•
Always adjust the blade speed relative to the material being cut
•
If blade tracking, tension, roller guides or changes are necessary please see shop tech for
assistance
Prechecks
•
Vice is securely holding work piece
•
Blade tracking
•
Blade roller guide spacing
•
Blade tension
Set up & Operation
Changing Blade Speed:
•
While standing in front of controls, on the right
side remove motor covers
•
Loosen handle on the bottom of the motor to
release tension on motor belt
•
Adjust belt to desired pully configuration,
reference chart on cover for speeds
•
Adjust motor so belt is tensioned
•
Tighten handle on underside of motor to hold
belt in place
•
Replace Cover
Work holding:
I
f material doesn’t reach half the vice width it is to
small to cut
•
Turn vise handwheel (A) 1/2 turn counterclockwise.
•
Move rack block (B) to desired location by sliding along the bed. Place the rack block onto the
rack.
•
Turn the handwheel to tighten
the vise.