FIGURE 3
UV INSERT INSTALLATION
1. Place the 1” Schedule 40 PVC pipe
in the coupler of the UV insert to help
determine where the 1” pipe should be
trimmed so that it is easily reached when
in the riser.
2. Remove the 1” Schedule 40 PVC pipe
from the coupler and trim it.
3. Glue the single side of the union to one
end of the 1” PVC pipe. See figure 3.
The opposite end will already be glued
to the bushing on the control
panel UV lamp wire.
4. Glue the other end of the 1” PVC pipe
into the coupler that is on the
UV insert.
5. Using a soft clean cloth moistened with
isopropyl alcohol wipe off the quartz
tube.
6. Gently set the UV insert in the UV
housing using the lifting handle. Be
sure that the Kapton edges curl into
the openings in the keyway shown in
Figure 4.
JET Model 952 UV Disinfection
Device Installation Instructions
FIGURE 4