Jet 891170, Operating Instructions And Parts Manual

Page: 9 / 52

9
ECB-1833DMEVS
6.0 UNCRATING AND ASSEMBLY
Note: Read and understand the entire manual before
attempting setup or operation.
1. Finish uncrating the saw and inspect for damage.
Should any have occurred, contact your local
distributor.
2. Remove all bolts attaching machine to shipping base.
3. Clean all rust protected surfaces with kerosene or a
cleaner/degreaser to remove protective coating.
Do not use gasoline, paint thinner, or mineral spirits,
as these may damage painted surfaces.
4. Lubricate all slideways with SAE 10W oil.
Shipping contents:
1 Band Saw
2 Splash Trays
1 Test Piece
1 Product Manual
1 Product Registration Card
1 Tool Box Complete (#ECB1833DMEVS-TBC), contains:
1 Adjustable Wrench 12”
1 Set of Open-end Wrenches
1 Set of Hex Wrenches
2 Screwdrivers (cross-point and fl at blade)
4 Leveling Bolts with Nuts
7.0 INSTALLATION
Use a forklift to set the band saw into position. It is not
recommended that a crane be used. Place the machine
on a fl at and level foundation of reinforced concrete. Allow
room for servicing and for moving large stock around the
band saw when deciding upon a location for the machine.
Maintain a minimum distance of 5 ft. (1500 mm) from the
rear of the machine to the wall.
Level machine with the provided bolts and nuts, and an-
chor it to the foundation with anchor bolts. Fig. 7-1 shows
hole pattern. NOTE: Accuracy and manufacturing toler-
ance of the machine can only be guaranteed if machine is
properly installed and leveled.
All leveling bolts should support the weight of the
machine evenly.
Fig. 7-1
Fig. 7-2
Fig. 7-3
8.0 COOLANT
Cutting fl uid or coolant must be supplied by the operator.
See sect. 14.4 for information.