Jet 891170, Operating Instructions And Parts Manual

Page: 17 / 52

17
ECB-1833DMEVS
Fig. 14-2
If future adjustment becomes necessary, turn knob A
counterclockwise to reduce pressure. See Fig. 14-2.
NOTE: If workpiece is thin, it is preferable to use a jig
instead of adjusting the hydraulic pressure.
14.6 MACHINE STORAGE
If the band saw is to be out of use for an extended period,
the following steps are recommended:
1. Disconnect from power supply.
2. Loosen tension on the blade.
4. Empty the coolant tank.
5. Clean and grease the machine.
6. Cover the machine if needed.
DO NOT turn knob B, and DO NOT change pressure
setting of hydraulic work table. The work table may
move too rapidly and cause a safety hazard.
Fig. 14-3
14.7 BELT ADJUSTMENT
If pulley slips or generates noise during operation, adjust
the tension knob (Fig. 14-3) clockwise to tighten the belt.
14.8 ADDITIONAL SERVICING
Any additional servicing should be done by qualifi ed
service personnel.