7
5.0
Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until Fence and
Rails are assembled and working properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of Shipping Container
(shown in Figures 1 and 2)
1
ProShop Fence – A
1 Handle
–
B
1
Rear Rail – C
1
Front Rail – D
1
Guide Tube – E
1
Scale – F*
2
End Covers – G
1
Hardware Package (JPSR-RHP) –
Figure 2
1 Owner's
Manual
1 Product
Registration
Card
* located inside Guide Tube (E)
6.0
Assembly and
Adjustments
Disconnect table saw from
power source before attempting any
assembly or adjustment.
6.1
Tools required for assembly
Hex wrenches, 4mm and 6mm
Open End Wrench, 13mm
Electric Drill with 3/16” and 5/16” drill bits (for
optional wood extension table only)
(4) C-Clamps, 4” to 6” (for optional wood
extension table only)
6.2
Installing Rails
Refer to exploded view in
sect. 7.0
for any
clarification of part positions.
1. Place
rear rail
against back edge of table,
making sure the notches in rail are properly
oriented. See Figure 3.
2. On the JPS-10TS table saw, insert four
M8x35 socket head cap screws with M8 flat
washers (plus M8 lock washers on the two
Figure 1
Figure 2
(NOTE: These are not to scale)
