10
Guide Tube
Referring to Figure 11:
The
guide tube
(A) is placed on top of the
front rail
(B) and is mounted with the scale facing toward
the operator.
1. Align the holes in the bottom of the
guide
tube
(A) with the holes in the
front rail
(B).
2. Fasten the
guide tube
(A) to the
rail
(B) from
beneath with 1/4-20 x 3/4 hex cap screws (C),
1/4 lock washers (F) and 1/4 flat washers (G).
Finger-tighten only.
3. Measure from the guide tube to the table top in
several places, to ensure it is parallel with the
table top. Adjust as needed, and tighten all
screws. Adjust as needed, and tighten all
screws with a 10mm wrench.
XACTA Fence
Screw the lock lever knob into the threaded handle
on the XACTA Fence II as shown in Figure 12.
The lock lever has three functional positions as
shown in Figure 13:
The upright position permits mounting and
removal of fence from the saw.
The unlock position permits easy fence
positioning.
The lower position locks the fence to the
front rail. The cam handle should be
pushed down firmly against the pin.
Figure 11
Figure 12
Figure 13
