Jet 10 Plus, Operating Instructions And Parts Manual, Page: 10 / 24

10
Controls
On/Off Switch
Before powering up the unit,
make sure all of the tools used to assemble and
adjust the unit are removed and accounted for.
Make sure your hands, loose clothing and any
other items that may get caught are safely away
from the unit.
The On/Off Switch (A, Fig. 4) is located on the front
of the sander. To turn the sander on, pull the switch
to the on position. To turn the sander off, push the
switch to the off position.
Switch Lock
The sander can be locked from unauthorized use
by locking the switch. To lock the switch:
1. Turn the switch to the off position and
disconnect the sander from the power source.
2. Pull the key (C, Fig. 4) out. The switch cannot
be turned on with the key removed.
Should the key be removed
from the switch in the on position, the switch
can be turned off but cannot be turned back on.
3. To replace the key, slide the key into the slot
on the switch until it snaps.
Circuit Breaker
The sander is equipped with a motor protective
device (circuit breaker). The breaker will
automatically shut the sander off when excessive
current is consumed.
If the breaker is tripped, turn the sander off and
reset the circuit breaker by pressing the
button
(B, Fig. 4).
Be sure to turn the sander off
before resetting the circuit breaker to avoid
unintentionally starting the sander
Figure 4