Jet Hangar A-7D/E Corsair II, Assembly Instructions Manual

Page: 32 / 66

JHI-A7-06-0001
Have questions? Call us at 562-467-0260 or email larrywjhi@jethangar.com 32
44. ‰
Locate the 7/8”x1/2” hardwood rails and glue
onto the front top of the engine mounting rails
using slow CA or epoxy.
‰
Drill the 4 outer attachment holes into the
accessory panel.
‰
Screw the accessory panel into place on the
hardwood rails.
Note: The wood may be soft
enough that pilot holes are not required in the
basswood rails.
‰
Finish connecting the engine and radio
equipment.
‰
Test fit the wing and connect the flap and
aileron connections. Clean up as necessary
any loose wires to allow accessibility to the
accessory panel.
6.2.7.2 Ducted Fan
45. ‰
Once all servo installations have been
completed, route the servo wires forward into
the nose of the aircraft.
‰
Install the receiver and receiver battery as
required to accommodate the aircraft cg.
‰
Route the receiver switch, flap and aileron
extensions, and air fill receptacles into the
forward wing saddle area.
46.
‰
Find the hardware accessory panel and 2
each 7/8”x1/2”hardwood rails.
‰
Cut the accessory panel down so that it
measures 3”x2.25”.
‰
Install the air fill valve for the retracts and the
receiver switch into the accessory panel.
‰
Install the receiver charge jack, aileron, and
flap extensions into “charge receptacles” and
install into the accessory panel.
‰
Drill 4 attachment holes into each of the 4
corners of the trimmed down accessory
panel.
‰
Screw the accessory panel into place on the
hardwood rails.
Note: The wood may be soft
enough that pilot holes are not required in the
hardwood rails.
Bevel Edges