7
MOUNTING YOUR FENCE TO THE TRACKS
Step 3:
MOUNTING YOUR FENCE TO THE TRACKS
a.
Slide the ¾” x 2-1/2” rectangular t-nut (Part
#
3
4)
for the extension knob into the t-slot next to the
scales on the fence tracks. See
Figure 5
. Repeat
this for the other side of the fence.
b.
Take two of the (4) 10-24 Stainless Steel
Hex Nuts (Part #
22
), and slide them into the t-slot
on the back of the fence. Repeat this step on the
other side of the fence. See
Figure 6
c.
Take the knob and mount assembly and line
up the hex nuts with the two holes in the mount.
See
Figure 7
. With two of the 10-24 x ½” Torx drive
stainless steel screws (Part #
7
), lightly thread them
into the hex nuts.
DO NOT TIGHTEN
at this point.
See
Figure 7
. Repeat this for the second knob.
Again, ensure you don’t tighten these fully.
d.
On one side, s
lide the knob and mount to line up the
hole in the
2-1/2"
t-nut you installed in Step 3 a)
.
T
hread the knob, but
DO NOT TIGHTEN.
C
enter
your fence from right to left
on the table and now
tighten up the clamping knobs.
NOTE: The knob and knob mount come
preassembled along with the Guard Mount
in a separate box in packaging.
Figure 5
Figure 6
Figure 8
Figure 9
Figure 7
