ADJUSTING THE FENCE SQUARE TO BLADE
1. Each of the three fence positions are
factory set for 90 degrees with the inside
edge of the table slide. After installing the
Mast-R-Slide, check to see if each of the
three fence positions are at 90 degrees to
the blade on your saw. If not you will need to
re-adjust the fence to a 90 degree angle.
2. Begin by unscrewing both fence locking
knobs and removing the fence from the
fence mounting “T”-nuts (hole “A” Fig. 29).
Using the 5/32” hex key, loosen the set
screw at hole “B” so that it is free from
contact with the track but does not protrude
above the surface of the hole.
3. Re-attach the fence by screwing the fence
locking knobs back into holes “A” (Fig. 29).
4. Loosen the set screw in hole “C” while
being careful not to allow the fence to move
from it’s current location.
FIG. 30
STOP BUSHING
FENCE MOUNTING
BLOCK
FIG. 29
A
B
C
5. Place a square between the face of the
fence and the saw blade and align the two
faces at 90 degrees to each other and
tighten the set screw (Fig. 30). Follow the
same steps for the two fixed 90 degree
positions at each end of the table slide. Then
follow the same steps and align the fence
face and saw blade to 90 degrees and also
line the fence face up with the “zero” on the
angle scale. Then tighten the set screw as
shown in (Fig. 30). Recheck the three
positions for squareness and repeat steps 1
thru 5 until each position is set square with
the saw blade.
6. Unscrew both fence locking knobs and re-
tighten the hidden set screw in the fence
mounting “T”-nut from step 2.
WARRANTY LIMITATIONS
This warranty does not cover:
!
Repairs or alterations made or
attempted by anyone other than JessEm
Tool Company or an authorized JessEm
service professional.
!
Normal wear and tear
!
Abuse, misuse or neglect.
!
Improper care or maintenance.
!
Continued use after partial failure.
!
Products that have been modified in any
way.
!
Products used with improper accessories
JESSEM TOOL LIMITED WARRANTY
All JessEm products are warranted to be
free from defects in material and
workmanship. JessEm will repair or replace
any product which upon inspection proves
to be defective for a period of (1) year from
dated receipt and proof of purchase. All
warranty claims should be made direct to
JessEm Tool Company. Contact JessEm for
a warranty claim return authorization and
instructions to proceed. The consumer is
responsible for shipping costs to return
product to JessEm Tool Company. We will
repair or replace the product at our
discretion and JessEm Tool will return
shipment to you at no charge.
