Figure 3
Figure 5
Note: If you are mounting the fence to a
JessEm table top proceed to the next
page section “For JessEm table”.
Measure the distance from the front edge of your
table to the center of the bit hole in the table top.
Transfer a mark the same distanced on both the
left and right edges of the table top. Then draw a
center line across the top of the table from one
Take one of the fence track assemblies and
line it up with the mark you made in figure 4.
Make a mark on the underside of the table
top to locate the same position on the bottom
of the table (Fig. 5).
Mounting the Fence Tracks to the Table
Figure 4
Figure 6
From the center line you drew, come three
inches toward the front of the table and mark a
small line on both the left and right sides of
the table (Fig. 4).
Flip the table top over and position the fence
bracket upside down and line up the front edge
with the mark you made in step 5. Using a
pencil or a 3/16” diameter drill bit mark the 4
holes for mounting the fence bracket. Pre-drill
the holes using a 1/16” diameter drill bit and
be sure you don’t drill through the table top
surface (Fig. 6). Using the #6 x ¾” wood
screws secure the fence track assembly to the
table. Repeat all steps for the second fence
bracket.
