•
The Skybound USB driver automatically installs when the Skybound adapter plugs into a
USB port.
The following messages appear near the System Tray:
When the message appears stating that the driver software has installed successfully,
the Skybound USB adapter is ready to be used.
4. Wait five seconds before attempting to program your Garmin datacard or inserting another USB
device into the same hub. The blue light needs to be steadily displayed.
The process of installing the Skybound USB driver needs to be complete any time the unit is plugged into
a new USB port (a port not previously used by the Skybound unit).
NOTE
If the automatic driver installation process fails, you can manually point the driver
installation wizard to the driver found in the JSUM application directory. Depending
on your setup and operating system, the default location is
C:\Jeppesen\JSUM\Driver
or
C:\Program Files\Jeppesen\JSUM\Driver
.
Using the Skybound USB Adapter
When you use the Skybound adapter after the driver is installed, make sure to use the following steps
when inserting the Skybound adapter into the USB port:
1. Launch
JSUM.
2. Plug the Skybound adapter into your computer.
3. Wait five seconds before attempting to program your Garmin datacard or inserting another USB
device into the same hub. The blue light needs to be steadily displayed.
Only one Skybound USB adapter can be programming a service at any one time. Do not attempt to
program two services with two Skybound adapters. While the Skybound adapter is going through the
programming phase, do not disconnect or connect another USB device into the same USB hub.
If you are having difficulties using the Skybound USB driver, refer to the JSUM help file.
