Jensen VM9022HDN - Touch Screen Double Din MultiMedia..., Installation And Operation Manual

Page: 10 / 64

6
VM9022HDN
CAUTION! Be careful not to damage the car wiring.
5. Complete wiring as illustrated in the wiring diagram on
page 3. Once the wiring is complete, reconnect the
battery negative terminal. If there is no ACC available,
connect the ACC lead to the power supply with a switch.
After completing the wiring connections, turn the unit on to
confirm operation (ignition switch must be on). If unit does not
operate, recheck all wiring until problem is corrected. Once
proper operation is achieved, turn off the ignition switch and
proceed with final mounting of the chassis.
1.
Connect wiring adapter to existing wiring harness.
2. Connect antenna lead.
3. Carefully slide the radio into the half-sleeve, making
sure it is right-side-up, until it is fully seated and the
spring clips lock it into place.
Using the Cosmetic Trim Ring
Two cosmetic trim rings are packaged with the VM9022HDN
for installation flexibility. The VM9022HDN will fit into most
import dashes with little or no modification to the dashboard
or cavity. Some US domestic vehicle dashes will accept a
Double-DIN chassis, but there is usually a small gap between
the radio and dash piece after installation is complete. In this
case, use the appropriate trim ring to conceal any gaps that
may be present.
The 4 tabs on the trim ring will snap into four holes on top and
bottom of the mounting sleeve.
Installing the MediaLink External AV
Connector
The MediaLink allows you to connect a variety of external
devices, including a VCR, DVD player, portable MP3 player,
etc., to your VM9022HDN without removing the radio.
To install the MediaLink, connect it to the AUX-IN cables on
the back of the VM9022HDN (see the Wiring Diagram on
page 3), and then install the MediaLink in a location
convenient for plugging in auxiliary devices.
Installing the Navigation Antenna
The VM9022HDN utilizes an external GPS antenna that must
be installed before accessing navigation features.
Since the navigation module uses GPS technology for
navigation, proper antenna placement is crucial for optimal
performance of the GPS receiver. When using GPS
antennas, the antenna plane should be parallel to the
geographic horizon. There should be nothing between the
antenna and the sky to ensure a direct line-of-sight between
the antenna and available satellites.
The preferred antenna location is on the top of the car on the
roof or trunk area. When placed on the dashboard,
performance may be reduced due to obstruction caused by
the window or roof.
NOTE: Do not cut the GPS antenna cable to shorten or
lengthen it.
Replacing the Fuse
When replacing the fuse, use a new 20A replacement fuse.
Using a fuse with an improper rating could damage the unit
and cause a fire.
MOUNTING SLEEVE
M3x4
SCREW
OPTIONAL
TRIM RING
TRIM RING
MOUNTING
SLEEVE