E-8
POWER SOURCE
An AC 120V ~ 60Hz power adapter with an output voltage of DC
15V 3A
is included with the
SMPS-750.
POWER CONNECTION
1. Insert the DC plug of the AC adapter into the DC IN Jack (#20) on the unit.
2. Plug the AC adapter into an AC wall outlet.
3. Set the POWER Switch (#19) and the LED Switch (#2) to ON.
4. The SMPS-750 will turn ON, and all the LEDs on the top panel and in the speakers will
light.
Note:
Please remove the AC adapter from the wall outlet and unplug it from the SMPS-750 if the
unit is not being used for extended periods of time.
CAUTION
:
Only use the AC adapter included with the SMPS-750. Using a different adapter could
damage the unit and void the warranty.
RADIO OPERATION
The following steps can also be completed using the remote control. Check the remote control
diagram for the corresponding buttons.
1. Press the POWER SWITCH (#19) located on the back of the SMPS-750 to turn ON the
unit. Press and hold the MODE/STANDBY BUTTON (#12) to wake up the system if
necessary.
2. Tap the MODE/STANDBY BUTTON (#12) repeatedly to select FM mode. The frequency
will show on the LED DISPLAY (#16).
3. Press the
BUTTON (#15) or
BUTTON (#13) repeatedly to manually tune to a
desired station.
4.
To automatically search for stations with strong signals, press and hold the
BUTTON (#15) or
BUTTON (#13)
until the frequency read out on display begins to
scan then release the button. The tuner will stop on the first strong station signal it finds.
5. Adjust the MASTER VOLUME CONTROL (#18) to the desired sound level.
To set / recall the radio presets
•
The unit can automatically search and store the preset memories. Press and hold the
PLAY/PAUSE
BUTTON (#14) for
4~5 seconds to activate auto preset mode and the
total number of stations can be stored depends on the signal strength of broadcasting
stations.
•
To recall one of the preset stations already programmed, tap the PLAY/PAUSE
BUTTON (#14) repeatedly until you reach the desired preset number/radio station.
Notes:
•
Use manual tuning to select weaker stations that might be skipped or missed during
automatic tuning.
•
If the automatic tuning does not stop on the exact frequency of the station, for example,
it stops on 100.9MHz instead of 100.8MHz, use the manual tuning method to "fine tune"
to the exact frequency of the desired station.
•
You can also direct enter the frequency by using the remote control.
For example, 88.1MHz (enter 881 with remote control), 100.8MHz (enter 1008 with
remote control).