Jensen JWM10A, Owner'S Manual, Page: 5 / 12

JWM10A
INSTALLATION INSTALLATION
It’s a good idea to read all of the instructions before beginning the installation.
We recommend having your Jensen JWM10A installed by a reputable RV
dealership.
You will need these tools and supplies to install your JWM10A:
Select a mounting location, taking care to avoid the following:
Ÿ
Phillips screwdriver
Ÿ
Wire cutters and strippers
Ÿ Tools to remove existing radio (screwdriver, socket wrench set or other tools)
Ÿ
Electrical tape
Ÿ
Crimping tool
Ÿ Volt meter/test light
Ÿ
Crimp connections
Ÿ 16 gauge wire for power connections
Ÿ
16 –18 gauge speaker wire
Tools and Supplies
Disconnecting the Battery
Selecting the Mounting Location
Mounting the Radio
To prevent a short circuit, be sure to turn off the ignition and remove the negative
(-) battery cable prior to installation.
NOTE: If the JWM10A is to be installed in a vehicle equipped with an on-
board drive or navigation computer, do not disconnect the battery cable. If
the cable is disconnected, the computer memory may be lost. Under these
conditions, use extra caution during installation to avoid causing a short
circuit.
Ÿ Places exposed to heat-radiating appliances such as electric heaters
Ÿ
Adjacent to other equipment that radiates heat
Ÿ
Poorly-ventilated or dusty places
Ÿ Moist or humid locations
Ÿ Use the mounting hole diagram to measure and cut a mounting hole
Ÿ
Route power, speakers, AV, and antenna cables through the hole and connect
Ÿ Check and ensure correct operation
Ÿ
Mount the unit using two M3x20mm (3/32 x 0.75") screws
Ÿ
Attach Trim ring
NOTE: Before cutting the mounting hole, make sure the area behind the
mounting location is clear of wires, fuel and vacuum or brake lines.
4