16
Display Information (Remote Control Only)
- During CD playback, press the “DISPLAY” button on remote control to toggle between
elapsed time or time remaining for the track being played.
RECORDING FUNCTION ON CD-2
Apart from the CD playback function,
CD-2
can perform the CD recording function either from
CD 1, PHONOGRAPH, TAPE or AUX modes. All recorded tracks will be stored in
“
AUDIO-CD
“ format.
Before starting, place a blank CD-R or CD-RW disc onto the
CD-2
tray. The disc will be able to be
recorded on if the LCD display shows the “NO TOC“ indicator.
NOTE:
A CD-R disc can only be recorded once and does not support erase or re-record function.
The playback quality of CD-R/RW discs vary depending on the type of audio CD player they are
used in.
Important Notices:
- The speed that the CD spins at in
CD-2
(CD Burner) is much higher than a normal CD
mechanism. Some mechanical noise and cabinet vibration may occur during operation. This is
normal and not a malfunction of the system.
- Quality and compatibility of CD-R/RW discs on the market varies. Please change to another
brand if you are having problems burning a specific type or brand of disc.
A) RECORDING MODE
I) CD RECORDING
i) Manual Recording
1) Tap the “FUNCTION” button to enter
mode. Place a source CD inside the
tray.
After the CD is read, press the “STOP ” button on CD 1 to stop the CD playback.
2) Load a recordable CD-R/RW disc into
CD-2
tray. Press the “REC “ button and then the CD
“PLAY/PAUSE
” button on
CD-2
until the recording indicator “ “ shows on LCD display.
3) After few seconds, the LCD will show the time counter notifying you that the system is
recording. Now start the playback of the CD in
tray.
4) During the recording process, you can record a desired session by pressing the “TRACK
SEPARATION”
button. A new CD track will be created and continue recording the next
session (track).
5) When the recording is completed, press the “STOP ” button on
CD-2
and then stop the
playback of
.
ii) Recoding by Program
1) Tap the “FUNCTION“ button to enter
mode. Place a source CD inside
tray in
STOP mode.
2) Select the desire tracks by following the “
CD Disc Programming
“ procedures.
3) Repeat the same procedures from step 2 to 5 as described on part A-I-i from above (manual
recording) to complete the recording process.
II) PHONOGRAPH RECORDING
1) Tap the “FUNCTION” button to enter “PHONO (phonograph)” mode. Place the record on the
turntable and get ready for playback.
2) Press the “REC “ button and then the CD “PLAY/PAUSE
” button on
CD-2
until the
recording indicator “ “ shows on LCD display.
3) After few seconds, the LCD will show the time counter and the system is now recording. Now
start the playback of the record in PHONO mode.
4) During the recording process, you can record a desired session by pressing the “TRACK
SEPARATION” button. A new CD track will be created and continue recording the next session
(track).
