E9
LISTENING TO THE RADIO
1.) Press the POWER button to turn the system "On", the LCD display will light up.
2.) Press the FUNCTION
button to select the Radio mode and the display shows “F” for
FM radio
, “A” for AM radio.
3.) Press the
/ AM/FM BAND button to select the desired band, AM or FM.
4.) Tune to your desired station with the TUNING knob. For FM radio, press the
FM-ST/MO button to switch between FM STEREO mode or FM MONO mode. If FM
STEREO is selected and you tune to an FM Stereo station, the FM STEREO LED
Indicator will light.
5.) Press the /- buttons to adjust the volume level as desired.
6.) When you are finished listening, press the POWER button to turn the unit off.
Antenna Information
AM -
The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM -
For best FM reception, the FM lead wire antenna located on the back of the set
should be fully unwound and extended. When an FM station is weak or distorted,
listening is usually improved by switching to FM Mono mode by pressing the
FM-ST/MON button.
PLAYING COMPACT DISCS
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to read all commercial CDs. It will
also read self-compiled CD-R/CD-RW discs, but it may take up to 10 seconds for the
actual playback to begin. If playback does not start, it is likely due to the quality of the
CD-R/RW disc and/or the compatibility of the CD compilation software. The
manufacturer is not responsible for the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
The following procedures can be accomplished by using the remote or controls on the
unit.
LOADING THE DISCS
1.) Press the POWER button to turn the system "On".
2.)
Press the FUNCTION button to select the CD mode and the display shows “Cd”.
3.) Press the
Open/Close button to open the CD tray.
4.) Insert a CD disc onto the tray.
5.) Press the
Open/Close button to close the CD tray. The CD player will read the
disc and display the total track number of the disc.
6.) If a CD cannot be recognized by the player or if no disc is loaded, the display will
show “no“.
NOTES:
Keep the CD disc tray closed when the system is not in use to prevent dirt and dust
from entering the CD mechanism.
Never place more than one CD in the CD tray. If two discs are loaded at the same
time, the CD mechanism may jam and / or the discs themselves may be damaged.
OPERATING INSTRUCTIONS
