8
®
CR560X
✓
Testing
Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.
Reconnect Battery
When wiring is complete,
reconnect the battery
negative terminal.
+
—
Test Memory Wiring
1. With the radio playing, hold
button 1 for two seconds.
CH 1 will appear on the
display. You just stored the
current station in memory.
2. Turn the key off, then turn
the key on again.
3. The radio should resume
playing at the same station
and volume. If not, make
sure the yellow wire is
connected properly.
Test Antenna Connection
Test Power Wiring
1. Turn ignition switch on. Press the
(Power) button to turn the radio on. The
display should light and show the radio
display. If not, check the electrical
connection at the yellow and red wires.
2. If equipped, the power antenna should
also operate. If not, check electrical
connections to the dark blue wire.
1. Hold a tuning button
for more than two
seconds. The radio
should tune to a
nearby station. If
not, check antenna
connection.
2. Press + to increase
volume until you
can hear the radio
playing.
1. Press DISP button for
three seconds until
display flashes.
2. Press
to change
minutes,
to change
hours.
Press DISP button to display the clock.
Set the Clock
or
VOL
+
2
1
1
1
2
DISP
2
1
M
H
5588 CR560X_EIN.p65
2/29/00, 10:46 PM
8
