4
Operating instructions
Start of the machine = for tractor pivot shafts at 540 rpm clockwise rotation.
Start machine at disengaged feeding and at slow pivot rotation.
Disengage feeding:
Push disengaging lever in direction knives – disc (position
„AUS“)
Engage feeding:
Pull disengaging lever in opposite direction (position „EIN“)
Recommended instructions during operation
Branch wood to be fed always with heavier end towards retraction rollers.
Should rotation of knives – disc drop during operation, push the disengaging lever,
wait until disc reaches full operating rotation again, then activate feeding again.
Check all screws and nuts for tightening.
V- belts
Check suspense regularly and re-tighten, if necessary.
Knives and counter – knife
Always keep a sharp edge in order to achieve an easy cut. The edges should always
be placed as close as possible towards the edge of the counter – knife.
Re – check knives regularly.
Knives, which due to re – sharpening get too narrow apart from the counter – knife
have to be compensated by respective spacers to adjust sketch.
Attention:
Even knives – discs moved by hand –in case of knives exchange- have,
due to their weight, sufficient force to result in squeeze injuries. Please watch at re –
grinding knives the respective drawing.