-4
4
-
9 Appendix
Problem
Cause
Solution
Battery is inserted in the wrong
direction
Reload battery in the correct direction.
Batteries are dead
Replace or recharge batteries
Power does not turn on
The battery compartment door is open Make sure the battery compartment
door is securely closed.
The flash is charging
Wait for the flash to charge.
Memory is full
Insert a new SD card
SD card is not formatted correctly
The card may be defective, use a new
card.
The camera does not take
pictures
Maximum file number is exceeded
Turn “File No. Reset” on, then format
the card or insert a new card.
The flash is charging
Wait for the flash to charge.
Image is not recorded
when the shutter button is
pressed
Memory is full
Insert an new SD card
The flash doesn’t fire
Flash is set to OFF
Set the flash to any mode except off.
The camera was moving when the
image was captured
Hold the camera steady when
shooting picture.
Image is blurry or out of
focus
The subject was beyond the range
within which the camera can focus
Turn the Macro mode on if the subject
is within 10 cm (zoomed out) or 50 cm
(zoom in) / don’t use Macro mode
when shooting distant subjects.
Image is not displayed on
the LCD monitor
An SD Card with non-DCIF images
(recorded with another camera) is
loaded
This camera cannot display non-DCIF
images.
Recorded images are not
saved in memory
The camera was turned off/powered
down before the image was stored in
memory
If the Battery Low indicator appears
on the LCD monitor, replace the
battery immediately.
Cannot transfer images to a
computer after connecting
the USB cable
USB driver is not installed
Install the USB driver before you
connect the camera to a computer /
turn the camera on.
Troubleshooting
