background image

Microwave Oven Use

For list of preset programs, see the Quick Reference Guide provided with your model.

Manual Cooking/Stage Cooking

Touch COOK TIME/POWER, touch number pads to enter time, touch 
COOK TIME/POWER again (if not 100%), touch number pads to enter 
power level (10-90), and then touch the Start control.

If programming additional stages (up to three), touch OPTIONS/
CLOCK to enter programming for the next stage, enter the cook time 
and cook power of each, and then touch the Start control.

Sensor Cooking

A sensor in the microwave oven detects moisture released from food 
as it heats, and adjusts the cooking time accordingly.

Make sure microwave oven has been plugged in for at least 1 minute. 
Use microwave-safe dish with loose-fitting lid, or cover microwave-
safe dish with plastic wrap and vent. For optimal performance, wait at 
least 30 minutes after convection cooking or grilling (on some models) 
before sensor cooking.

Add More Time

At the end of any cycle using less than 100% cook power, “PRESS 0 
TO ADD MORE TIME” scrolls in the display. Enter the additional time, if 
desired, and start the microwave oven. The cook power for all non-
sensor cycles will be the same as in the finished cycle, but may be 
changed. If Add More Time is used after a sensor cycle, the cook 
power will be 100%, but may be changed.

Doneness

Adjust doneness for automatic cooking functions by touching COOK 
TIME/POWER repeatedly to scroll through “NORMAL,” “MORE 
DONE” or “LESS DONE” within the first 20 seconds of starting the 
cook cycle. Doneness cannot be adjusted for Defrost functions.

Warm Hold

Hot cooked food can be kept warm in the microwave oven. The Warm 
Hold function uses 10% cook power. Warm Hold can be used by itself 
or can be programmed to follow a cooking cycle. Opening the door 
during Warm Hold will cancel the function.

General Cleaning

IMPORTANT: Before cleaning, make sure all controls are off and the 
microwave oven is cool. Always follow label instructions on cleaning 
products.

To avoid damage to the microwave oven caused by arcing due to soil 
buildup, keep cavity, microwave inlet cover, cooking rack supports, 
and area where the door touches the frame clean.

Clean with mild soap, water and a soft cloth or sponge, or as indicated 
below.

Grease filter: mild soap and water or dishwasher.

Door and exterior: mild soap and water, or glass cleaner applied 
to paper towel.

Control panel: sponge or soft cloth and water.

Stainless steel (on some models): mild soap and water, then rinse 
with clean water and dry with soft cloth, or use stainless steel 
cleaner.

Turntable: mild soap and water or dishwasher.

Rack(s): mild soap, water and washcloth. Dishwasher cleaning is 
not recommended.

Installing/Replacing Filters and Light Bulbs

NOTE: A filter status indicator (on some models) appears in the display 
when it is time to replace the charcoal filter, and clean or replace the 
grease filters. See “Settings” section to reset filter status.

Grease filters: Grease filters are on the underside of microwave 
oven. Clean monthly, or as prompted by filter status indicator. 
Slide the filter away from the tab area, and drop out the filter. To 
reinstall, place end of the filter into the opening opposite the tab 
area, swing up the other end, and slide it toward the tab area.

Charcoal filters: The charcoal filters are behind the vent grille at 
the top front of the microwave oven. The charcoal filters cannot 
be cleaned, and should be replaced about every 6 months, or as 
prompted by filter status indicator. Remove two screws on the 
vent grille, tilt the grille forward, lift it out, and remove filters. To 
reinstall, place each filter into its slotted area – wire mesh side up, 
replace vent grille, and secure with screws.

Cooktop light: The cooktop light is located on the underside of the 
microwave oven, and is replaceable. Remove bulb cover screw, 
and open the bulb cover. Replace bulb, close bulb cover, and 
secure with screw.

Cavity light: The cavity light bulb is located behind the vent grille 
at the top front of the microwave oven, under the bulb cover, and 
is replaceable. Open door. Remove two screws on the vent grille, 
tilt the grille forward, and lift it out. Remove right side charcoal 
filter. Open bulb cover and replace bulb. Close bulb cover, replace 
charcoal filter, replace vent grille, and secure with screws.

WARNING

Food Poisoning Hazard

Do not let food sit in oven more than one hour before 
or after cooking.

Doing so can result in food poisoning or sickness.

Microwave Care

Summary of Contents for W10619038A









Reviews: