22
Install Top Grille Panel
Standard Integrated Grille Installation—Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
2. Pull the grille panel down slightly to lock into place.
Fully Integrated Grille Installation—Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into
place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure
the refrigerator door(s) can open freely. If the door(s) opens too
wide, install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a
⁵⁄₃₂
" hex key, tighten the door stop pin.
Complete Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
■
Custom wood overlay panels may be made with a
³⁄₈
"
(0.95 cm) or
¹⁄₈
"
(0.32 cm) gap between the panel and
cabinets and a
¹⁄₈
"
(0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
■
All purchased panel kits require a
³⁄₈
" (0.95 cm) gap
between the panel and the cabinets and a
¹⁄₈
"
(0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
2. Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
■
Slide the panel from side to side in the keyhole slot.
A. Top grille panel
B. Cabinet sides
A. Panel brackets
B. Grill trim piece
B
B
A
A
B
A. Door stop pin hole
A. Adjacent cabinet
B. Installation block
C. Panel on door
A
B
A
C
