Jenn-Air W10253462A, User Manual

Page: 15 / 40

15
Style 2: Direct wire strain relief
■
Use Phillips screwdriver to remove screws from panel on
back of range.
■
Lift range back panel up and off.
■
Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
■
Position cord/conduit plate as shown in the following
illustration.
■
Replace cord/conduit plate and insert screws.
■
Assemble a UL listed conduit connector in the opening.
■
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
RE MO
VE TA G! US E
NU TS WIT H P OW
ER CO RD
NU TS WIT H P OW
ER CO RD
QU
ITE LA ET IQU ETA
US E L AS
TU ER CA S
PA RA CO NE CTA
R E L
CO RD
ÓN EL ÉC TR ICO
RE MO
VE TA G! US E
NU TS WIT H P OW
ER CO RD
QU
ITE LA ET IQU ETA
PA RA CO NE CTA
R E L
CO RD
ÓN EL ÉC TR ICO
RE MO VE TA G! US
E
NU TS WIT
H P OW ER CO RD
NU TS WIT
H P OW ER CO RD
QU ITE LA ET
IQU ETA
US
E L AS TU ER CA
S
PA RA CO
NE CTA R E L
CO RD ÓN EL ÉC
TR ICO
RE MO VE TA G! US
E
NU TS WIT
H P OW ER CO RD
QU ITE LA ET
IQU ETA
PA RA CO
NE CTA R E L
CO RD ÓN EL ÉC
TR ICO
A. Removable retaining nut
B. Strain relief
A
B