18
IMPORTANT:
Adjust in small increments to keep from
damaging the cabinet trim and causing problems
with the door alignment or top grille fit. To avoid
damage to the cabinet or leveling legs, do not apply
more than 50 inch-pounds (5.65 Nm) of torque to the
leveling bolts. The leveling legs can be extended to a
maximum of 1¹⁄₄" (3.18 cm) below the rollers.
4.
After leveling the refrigerator, use a straight edge or
4-ft level going across the front of the refrigerator
installation to the cabinets to check that the
refrigerator is still flush.
INSTALL PANELS
Refer instructions received with full height door panel
kit /Armoire kit to install stainless steel / Custom Wood
Overlay Panels.
IMPORTANT:
JennAir is not responsible for the removal
or addition of molding or wood overlay panels that would
not allow access to the refrigerator for service.
INSTALL BASE GRILLE
There are two pieces to the base grille to allow for a
custom fit: the base grille itself and the skirt. The skirt can
be added to the base grille in order to extend it all the
way to the floor.
1.
To see whether the skirt is needed, place the base
grille into
position. Do not attach the base grille to
the refrigerator. Measure the distance between the
bottom of the base grille and the floor. The gap must
be a minimum of 1/2" (1.27 cm) in order to add the
skirt.
NOTE:
If the gap measures less than 1/2" (1.27 cm),
skip steps 3 and 4 of the instructions, and install the
base grille only.
2.
Remove the film from the base grille. Snap the skirt
onto the base grille.
3.
Trim the skirt by scoring the proper “V” groove with a
utility knife. Break the skirt at the score line.
4.
Using the two screws, attach the base grille assembly
to the refrigerator as shown.
NOTE:
Drive in the right side screw first.
A
B
C
D
A. Two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards
B. Attach to studs with six #8 x 3" (7.6 cm) screws
C. Compressor cover
D. Distance from bottom of anti-tip boards to floor
A
B
.
A
A
2" (5 cm)
84"
(213.4 cm)
A. Base grille
B. Skirt
A. “V” groove
A. Screws (2)
