Jenn-Air NOIR JMC2427LM, Owner'S Manual

Page: 7 / 24

7
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Electrical Connection
To properly install your microwave oven, you must determine the
type of electrical connection you will be using and follow the
instructions provided for it here.
�
Microwave oven must be connected to the proper electrical
voltage and frequency as specified on the model/serial/rating
plate. The model/serial/rating plate is located underneath the
control panel along the oven vent.
A. Model/serial/rating plate
�
The microwave oven rated 120/240 V, 20 A, has 4 wires (L1,
L2, N, and G) in the flex conduit, and should be connected to a
20 A maximum-rated circuit, overcurrent protected on both the
L1 and L2 circuits.
�
A time-delay fuse or circuit breaker is recommended.
�
Flexible cable from the microwave oven should be connected
directly to the junction box.
�
Do not cut the conduit. The length of conduit provided is for
serviceability of the microwave oven.
�
A UL listed or CSA approved conduit connector must be
provided.
�
If the house has aluminum wiring, follow the procedure below:
Connect the aluminum wiring using special connectors and/or
tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer’s recommended
procedure. Aluminum/copper connection must conform with local
codes and industry accepted wiring practices.
For power requirements, refer to the following table:
Voltage Microwave With Convection
Oven
240 VAC 19.9 A/3250 W
208 VAC 19.9 A/3250 W
INSTALLATIONS
Spacer Kit Installation (For
Microwave Ovens)
NOTES:
�
The microwave oven spacer kit allows the microwave oven to
be installed in an 17
7
/
16
" to 17
7
/
8
" (44.1 cm to 45.3 cm)
maximum cutout height.
�
If your cabinet cutout height is more than 17
7
/
16
" (44.1 cm), you
must install the spacer kit. Proceed to “Assemble Spacer Kit.”
�
If your cabinet cutout height is less than 17
7
/
16
" (44.1 cm), you
do not have to install the spacer kit. Proceed to “Prepare
Built-In Microwave Oven.”
�
For a flush install, a taller bottom vent trim is needed. Please
see your Quick Start Guide for a number to call and order this
part.
Assemble Spacer Kit
1.
Attach the bottom vent to spacer bars using four 3/8" (9.5 mm)
hex-head washer screws.
NOTE: Spacer bar flanges should be facing out.
A. Bottom vent
B. Spacer bar flange
C. Spacer bars
D. 3/8" (9.5 mm) hex-head washer screws
Install Spacer Kit
1.
Center assembled microwave oven spacer kit against lower
front edge of the cabinet cutout.
2. Using an 1/8" (3.2 mm) drill bit, drill through the mounting
holes in the spacer bars to create pilot holes.
3. Attach the assembled spacer kit to the cabinet using four
3/4" (1.9 cm) (pan-head screws). Do not overtighten screws.
A. 3/4" (1.9 cm) flat-head screws
B. Spacer kit assembly