Jenn-Air JS42NXFXDE, Installation Manual

Page: 22 / 72

22
4. Using slotted hex-head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
Install Top Grille Panel
Standard Integrated Grille Installation—Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
2. Pull the grille panel down slightly to lock into place.
Fully Integrated Grille Installation—Full Height Grille
1. Align the bracket on each side of the top grille panel with
the mounting bolts.
2. Push the grille panel forward until the bracket snaps into place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure the
refrigerator door(s) can open freely. If the door(s) opens too wide,
install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a
⁵⁄₃₂
" hex key, tighten the door stop pin.
Complete Panel Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
■
Custom wood overlay panels may be made with a
³⁄₈
" (0.95 cm) or
¹⁄₈
" (0.32 cm) gap between the panel
and cabinets and a
¹⁄₈
" (0.32 cm) gap between the freezer
and refrigerator door(s) and the door(s) and top grille.
■
All purchased panel kits require a
³⁄₈
" (0.95 cm) gap
between the panel and the cabinets and a
¹⁄₈
" (0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
2. Adjust the panel to achieve the required spacing or to align.
IMPORTANT: If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
■
Slide the panel from side to side in the keyhole slot.
■
Use a
⁵⁄₃₂
" hex key to raise or lower the adjustment pins,
which allows the door panel to swivel.
A. Bottom hinge B.Mounting bracket
A. Top grille panel
B. Cabinet sides
A. Panel brackets
B. Grill trim piece
A B
B B A
A
B
A. Door stop pin hole
A. Adjacent cabinet C.Panel on door
B. Installation block
A. Door panel
B. Mounting bracket
C. Adjustment pins
A
B
A
C
A
B
C