Jenn-Air 720-0336B, Installation Instructions And Use & Care Manual

Page: 12 / 96

12
6. Use an adjustable wrench to remove the LP regulator from
the manifold.
7. Use an adjustable wrench to install the Natural gas regulator
hose to the manifold and secure. Attach the Natural gas
regulator to the side panel inside the grill cart with the two
screws that are preassembled on the regulator.
Make Gas Connection
1. A combination of pipe fittings must be used to connect the
grill to the existing gas line.
■
The 10 ft (3.0 m) PVC flexible gas supply hose design-
certified by CSA must be used.
■
Pipe-joint compounds suitable for use with Natural gas
must be used. Do not use Teflon
®† tape.
■
There must be a certified manual shut-off valve in the gas
supply line near the grill for easy access.
2. Use a pipe wrench to connect the brass connector on one
end of the 10 ft (3.0 m) PVC flexible gas supply hose to the
Natural gas pressure regulator.
3. Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe. To use the quick connect fitting; pull the
head of the quick connect back, insert the end of the PVC
gas hose and release the head of the connector. Check the
the connection is secure.
Change Grill Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the 2 screws that hold the burner in place. Set the
screws aside. Remove the burner from the grill by lifting the
burner out.
†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
A. Manifold
B. Left side panel
C. Natural gas pressure regulator/hose assembly
D. 10 ft. (3.0 m) PVC gas hos
A. 2 screws
A
B
C
D
A