CARE & MAINTENANCE OF THE GRILL
STAINLESS STEEL
The grill is made of non-rusting and non-
magnetic stainless steel. There are many
stainless steel cleaners available. Always use the
mildest cleaning procedure first, scrubbing in the
direction of the grain.
To touch up noticeable scratches in the stainless
steel, sand very lightly with dry 100 grit emery
paper in the direction of the grain.
Grease specks can gather and bake onto the
surfaces of the stainless steel, giving the
appearance of rust. For removal, use an
abrasive pad with a stainless steel cleaner.
GRILL RACK
The easiest way to clean the grill is immediately
after cooking is completed, and the flames have
been turned off.
Wear a barbeque mitt to protect your hand from
the heat and steam.
Scrub the hot grill by dipping a bristle barbecue
brush in tap water. Cleaning will be more difficult
if the grill is allowed to cool.
CAUTION
Before cleaning, make sure the gas supply and
control knobs are in the “OFF” position, and the
burners have cooled.
GRILL BURNERS
Extreme care should be taken when moving a
burner. It must be correctly centered on the
orifice before any attempt is made to relight the
grill. Frequency of cleaning will depend on how
often you use the grill.
WARNING
Failure to properly place the burner over the
orifice could cause a fire to occur behind and
beneath the valve panel, thereby damaging the
grill and making it unsafe to operate.
GRILL BURNER REMOVAL/INSTALLATION
The grill burners are factory installed.
To remove the main burners for cleaning:
1. Locate the cotter pin at the rear of the burner
on the bottom side.
2. Remove the cotter pin and lift the burner out
of the fire box.
To reinstall the main burners:
3. Insert the burner over the valve assembly
(Item# 11 on Page 18).
4. Insert the back of the burner into the hole at
the rear of the fire box and reinsert the cotter
pin.
GREASE TRAY CLEANING
The grease tray should be emptied, wiped down
and washed periodically in a mild detergent and
warm water solution.
A small amount of sand or cat litter may be
placed in the bottom of the grease tray to absorb
the grease. Check the grease tray frequently.
Do not allow excess grease to accumulate and
flow out of the grease tray.
GRILL BURNER CLEANING
1. Turn off the gas supply, and make sure the
control knobs are in the “OFF” position.
2. Make certain the grill is cool, and clean the
exterior of the burner with a wire brush. Use
a metal scraper for stubborn stains.
3. Clear clogged ports with a straightened
paper clip. Never use a wooden toothpick. It
may break off and clog the port.
4. If insects or other obstructions are blocking
the flow of gas to the burner, call customer
service at 1-800-554-5799.
16
Summary of Contents for 720-0061-LP
Page 20: ...EXPLODED VIEW 18...
