7
12. Attach the upper horizontal support bracket with 4 - 5 x
45 mm wood screws.
Install Range Hood
1. Position the 4 vertical supports (A) with the notches at the
bottom and attach to the range hood using 16 - 4 x 8 mm
screws.
2. Attach the horizontal support (B) using 8 - 4 x 8 mm screws.
3. Attach a second set of vertical supports (A) and set the
vertical height (B). See “Installation Clearances” in the
“Location Requirements” section to help determine the
desired dimension for vertical height “B.”
4. Using 2 people, place the glass mantle onto the range hood.
5. Connect glass mantle to range hood with the 2 glass
mounting brackets and 4 - 3.5 x 9.5 mm screws.
6. Attach the range hood assembly to the upper horizontal
support attached to the ceiling using 16 - 4 x 8 mm screws
and tighten.
Connect Vent System
1. Install vent system.
2. Push duct over the exhaust outlet. Seal all connections with
vent clamps.
Non-Vented (recirculating) Installation
1. Attach the air deflector to the upper horizontal support using
4 mounting screws.
2. Measure the length of 8" (20.3 cm) duct (not included)
needed to connect the transition to the deflector.
NOTE: Vent should fit up inside the deflector 1" (2.5 cm)
minimum.
3. Install vent between the transition and the deflector.
NOTE: To make vent installation easier, temporarily remove
the deflector from the chimney support bracket and replace
after vent section is in place.
4. Seal all connections with vent clamps.
A. Upper horizontal support
A. Vertical supports
B. Horizontal support
C. Notched end
A. Vertical suppoarts
B. Vertical height
A. Glass mantle
A
B
A
A
C
C
B
A
A
A
A. Glass mounting bracket
B. 3.5 x 9.5 mm screws
A. Mounting screws
A. Deflector
B. Mounting screws
A
A
B
A
B
A