8
4. Repeat steps 1-3 for the underside of the top of the cabinet.
Wall Venting Under Cabinet
To make a 3½" x 10½" (8.9 cm x 26.7 cm) rectangle in the
wall:
1. Make 2 lines by measuring
³⁄₈
" (9.5 mm) and 3
⁷⁄₈
" (9.8 cm)
down from underside of cabinet and mark on the centerline
on the back wall.
2. Mark lines 5¼" (13.3 cm) to the right and left of the centerline
on the wall.
Use saber or keyhole saw to cut a rectangular opening in the wall
for the vent.
3. Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
4. Use
¹⁄₈
" (3 mm) drill bit and drill 4 pilot holes as shown.
5. Install the 4 - 4.5 x 13 mm mounting screws in pilot holes.
Leave about
¹⁄₄
" (6.4 cm) space between screw heads and
cabinet to slide range hood into place.
For Wall Installations:
1. Determine and mark the centerline on the wall where the
canopy hood will be installed.
2. Select a mounting height between a minimum of
30" (76.2 cm) and a suggested maximum of 36" (91.4 cm)
above the range to the bottom of the hood. Mark a reference
line on the wall.
3. Using 2 or more people, center the hood on the vertical
centerline, then align the bottom of the hood with the
horizontal reference line marked on the wall.
4. Mark centers of the fastener locations to the wall. Set range
hood aside on a covered surface.
IMPORTANT: All screws must be installed into wood. If there
is no wood to screw into, additional wall framing supports
may be required.
5. Drill
³⁄₁₆
" (4.8 mm) pilot holes at all locations where screws are
being installed into wood.
6. Install the 2 - 5 x 45 mm mounting screws. Leave a
¹⁄₄
" (6.4 mm) gap between the wall and the back of the
screw head to slide range hood into place.
7. Determine and make all necessary cuts in the wall or ceiling
for the vent system. Install the vent system before installing
the hood. See “Venting Requirements” section.
A. Keyhole slot
A. Drill pilot hole.
5
¹
/
₄
"
(13.3 cm)
5
¹
/
₄
"
(13.3 cm)
*3
⁷⁄₈
"
(9.8 cm)
*From wall, not cabinet frame
Cabinet cutouts
*
³⁄₈
" (1.0 cm)
³⁄₈
"
3 ⁷⁄₈
"
Cabinet
front
5
¹⁄₄
"
(9.5 mm)
(9.8 cm)
(13.3 cm)
Centerline
A
A
¹⁄₄
"
(6.4 mm)
A. Horizontal reference line
B. Vertical centerline
C. Mounting height
D. Cooking surface
A. Keyhole slot
A. Drill pilot hole.
A
C
B
X
D
A
A
¹⁄₄
"
(6.4 mm)