13
1. Rinse unit carefully with distilled water. After rinsing and drying,
inspect and clean connectors to remove all contaminants that
may affect probe connections.
2. Wait for the unit and probe to dry completely before resuming
operation.
3. If the unit does not function correctly after steps1 and 2, call
JENCO for possible repair or replacement
(see Warranty).
INSTALLING THE BATTERIES
The 9020M meter is packaged with one 9V battery required for
operation. To insert the batteries into the meter, follow the
procedure outlined below.
Figure 1: Battery compartment
1.
Use a screw driver to remove the two screws and battery
cover to expose the battery compartment. (Figure 1.)
2.
Replace the 9V battery.
3.
Replace the battery cover and make sure to secure the two
screws for the water-tight feature.
[
Note:
Press the “ON/OFF” key to turn the unit on. If the unit is
running then you can press the ”ON/OFF “ key to turn the unit
off. The unit will automatically turn off after 45
minutes of no key
activity.]
Summary of Contents for VisionPlus 9020M
