5.5
Mounting motorcycle wheels' holder
ATTENTION: Motorcycle wheels' holder is not standard equipment and -
if needed - can be purchased separately
WARNING: The wheel balancer may be delivered with an already
mounted holder.
Mounting motorcycle wheels' holder is very similar to mounting car wheels' holder, which
was described in chapter 5.3. In fig. 5.6 the holder has been presented and all of its parts
described.
For proper holder mounting, the holder's bar with a matching base (1) should be placed on
the machine's spindle (1 in fig. 5.2). Secondly, the holder's axis (3) is to be screwed to the
spindle using the shorter thread and tightened using a size 22 wrench.
Fig. 5.6 Motorcycle wheel's holder elements:
1 : holder's bar with a base 4: cone muff - 2 pcs.
2: tyre clamps
5: distance muff - 6 pcs.
3: holder's axis
6: holder's screw.
5.6
Mounting the hood
The description and numeration below is based on figure 2.1.
-
Unscrew all bolts from the collar (3),
-
While holding the hood (1) set it in such position that holes in arm of the hood (2)
are aligned with holes in the collar (3),
-
Screw the arm (2) to the collar (3).
-
18
-